I used my binding bit to set the edge for the carve. Rough carved with the Grinder. And cleaned up with a 50 grit sanding disk.
After cleaning up with the DA and some 80 grit. I will work through the grits and fix a few little dibbles.
Thursday, November 19, 2009
And now for something completely different...
Rear routes before I thin the body.. then after losing 3/8" from the back.
I used my binding bit to set the edge for the carve. Rough carved with the Grinder. And cleaned up with a 50 grit sanding disk.
After cleaning up with the DA and some 80 grit. I will work through the grits and fix a few little dibbles.
I used my binding bit to set the edge for the carve. Rough carved with the Grinder. And cleaned up with a 50 grit sanding disk.
After cleaning up with the DA and some 80 grit. I will work through the grits and fix a few little dibbles.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.