I think this needs no introduction.
Fretboard attached with the marching hammers.
Cleaning up the sides of the neck after attaching fretboard.
The fretboard was a little thin so I added a maple veneer under it... now we have a distinct line.
Neck fit.
Headstock wings on. This is a non-reverse as I didn't think the rev headstock would look good on this one.
Headstock plate to match the top.
Fretboard attached with the marching hammers.
Cleaning up the sides of the neck after attaching fretboard.
The fretboard was a little thin so I added a maple veneer under it... now we have a distinct line.
Neck fit.
Headstock wings on. This is a non-reverse as I didn't think the rev headstock would look good on this one.
Headstock plate to match the top.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.