After a pass with the spiral template bit the edge is so smooth that it doesn't need to be sanded. I think it might have been worth the $72.50. The few marks in the template are from were the bandsaw blade was a little too close to the template.
Tuesday, April 27, 2010
Spiral bits
Working on the back of the guitar since the top hasn't arrived yet. To start I knocked off the high glue line and drew the outline of the template on the blank. Next up bandsaw the body really close to the template with a 1/4" blade. Attach the template with tape and move to the new router table. Hopefully the new spiral template bit will help with any tear out.
After a pass with the spiral template bit the edge is so smooth that it doesn't need to be sanded. I think it might have been worth the $72.50. The few marks in the template are from were the bandsaw blade was a little too close to the template.
After a pass with the spiral template bit the edge is so smooth that it doesn't need to be sanded. I think it might have been worth the $72.50. The few marks in the template are from were the bandsaw blade was a little too close to the template.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.