Tuesday, September 28, 2010

Carve top... almost.

3/16" radius to set the depth of the carve. This will have the soft edges like the other one...



Carve Progress picks. I always start at the arm rest and work towards the horn.




The spalt on at the but of the body was very difficult to cut evenly... a little CA and some hand sanding with a curve sander and all is good.



I am tired now and that is when mistakes are made so I am stopping for today. We are not done. The horns have to be softened a lot... the edges are too sharp at this point. Once I soften this I will harden the spalt and sand it up. Maybe tomorrow...



More pictures.





No comments:

Post a Comment

Note: Only a member of this blog may post a comment.